ບັນຫາທົ່ວໄປແລະວິທີແກ້ໄຂສໍາລັບ faucets ຮົ່ວ

Faucets are one of the more frequently used items in the home

Over time, problems are inevitable.

ຍົກ​ຕົວ​ຢ່າງ

Faucets not closing properly, dripping and leaking ……

It’s leaking.

The water bill is also a big expense.

Now I will tell you a few simple ways to repair it.

Focusing again on the faucet’s bubbler.

Like the Moen faucet aerator.

It makes the water that comes out plump and full.

thereby washing more stuff with less water.

effectively reduce water consumption and conserve water.

And in use.

It won’t make water splash everywhere.

02 Faucets that don’t close properly

If after replacing the gasket.

Found that the faucet was still leaking.

It is likely that there is a problem with the ceramic piece below the gasket.

Then you will have to replace the corresponding ceramic valve core.

If most of the Moen faucets you use in your house are constant spool valves.

Its drive shaft is made of steel.

Integral gasketing.

Able to adapt to a variety of environments.

Making sure that the faucet doesn’t leak in poorer environments.

Durable. 03 Leaks elsewhere.

If it feels like there’s always a crack in the faucet leaking.

The cause may be a damaged O-ring.

The O-ring is located at the point where the base meets the tap.

In case of damage.

Just replace the O-ring by following the steps above.

Other than that.

A leaky faucet could also be the result of damage to the water stopping tape on the faucet section.

This is the time to replace the water stopping tape.

With the tap removed.

The problem can be solved by winding the threads 5-6 times clockwise with air-printing tape.

In future situations like this.

You can easily do this at home.

If the faucet is too old.

Still leaking and dripping after repairs.

Then a new one is recommended.

PS: A little common sense.

The faucet had a lot of water coming out of it when it was first installed.

With a period of time water out of the small, how to solve it?

One scenario is.

Some faucets are designed to protect the life of the spool.

Added sediment trap in front of the water main.

This can be solved with regular cleaning.

There is also the case of.

Our bubblers are clogged.

causing clogging of the bubbler we just need to clean the sediment off the bubbler regularly.

You’ll be able to restore the water flow from the faucet.