Installation points of different types of faucets

Prepare the installation tools and check whether the supporting parts are complete before installation. Common faucet parts are: exercituum, rubber washers, imbres, drains, crutches, decorative caps, etc.

Installation of single-hole basin faucet

Cum emebant unum-manubrium faucet pelvem, you should pay attention to the diameter of the spout. Hodie, most of the water in the market belongs to the hard pipe, so you should pay attention to the height of the upper spout. It is appropriate to go down from the basin 35 work points**. Per institutionem, specialis angulus valvae eligendus est, and the angle valve must be fixed to the hot and cold water pipes from the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. memento, you must not use other water pipes to connect, because if the water pressure is high, it will easily fall off and leak water, causing you loss. Si limbum fistula nimis longum est quam exitus fistulae, the part can be cut off according to your needs. If the angle is not appropriate, you can bend it to the position you need. memento: Do not bend hard to 90 gradus vel plus 90 gradus. Cum installing labrum exhaurire, please don’t forget to purchase the small connector of the faucet (breve spatium faucet). Please don’t forget to flush the water pipe buried in the wall before you install it.

Installation of imbrem et balneus faucet (wall hanging)

After you have purchased a shower, balneus, murus conscendit faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Before installation, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet.

Abscondita est imber et balneus faucets: Occultatum faucet emendo, valvae nucleus faucet plerumque praeiacente muro. Be sure to pay attention to the thickness of the bathroom wall before embedding. Si murus nimis tenuis, valvae core non embedded. Tutela nuclei valvulae plasticae ne auferas facile in pre-embedding, ad vitandum damnum valvae core per caementa et alia chores. Autem, ut sursum deorsumque observandum, dextra parte FUSUS cum embedding FUSUS ad iniuriam FUSUS. When the wall-mounted faucet is pre-embedded in the water inlet pipe, there is a deviation in the size, and the adjustable crutches can be used to adjust the position.

Institutionem faucet thermostaticae

Antequam installing faucet thermostatic, please check if the water pipes are hot on the left and cold on the other. Remember not to connect the hot and cold water pipes wrongly to avoid the faucet not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Don’t forget to install the hot and cold water filter when installing the thermostatic faucet.